How to Set PT Settings for the Special PT Rule - Override to Default Rule for Specific Labor Input Only

This setting will bill Special PT Rule as Follows -

1. Special Premium Time Rule - Specific to Single Labor Input Only - This will override DEFAULT PT RULE when used
   

2. User must Check Box to "Enable This PT Rule" (see image below)
   

3. User must set up this rule - see example set up below - It is set to bill as follows
   

4. First 8 Hours Bill Regular Rate - Then from 8 Hours to 10 Hours it bills PT at 1.500 factor and then 10+ Hours bills PT at a PR factor that is set
   

• IMPORTANT NOTICE :  Each Rule must have an Hourly Value. Do Not Leave any Hours at 0.00 or the PT will not be processed correctly.  Each of these values are processed by the program.  If you leave one at 0.00 then the program will still process this. Even if you have no PT Rule for the second additional rule then you must still enter value and it can match the first PT special Rule. Example. Lets say the rule is only one PT value and that is Regular Rate to 10 Hours then PR with a factor of 1.5 after 10 Then you should set up the Special PT Rule as "Set Daily Regular Hours" to 10 "Bill Premium Time That Exceeds Regular Hours at the Factor" 1.500 Then for the next rule you would Enter "Additional PR starts after" 10 "Hours at this factor" 1.500
  

1. If you used the Special PT Rules and Need to Remove them from your bill/inputs, follow instructions below 
2. Go back to each input and modify to un-check the box for Apply Special PT Rule
   
3. Once you have completed this for every input then go to the Premium Time Settings and Un-check "Enable the PT Rule"
   
4. Click on the ENTER button to go back to project settings
   
5. Click the ENTER Button to refresh the bill with the new settings.